Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMMANDER 4WD V8-5.7LREPAIR AND DIAGNOSISBODY AND FRAMEFENDERFRONT FENDERSERVICE AND REPAIRFRONT FENDER - INSTALLATION
2009 Jeep Commander 4WD V8-5.7L
Front Fender - Installation
2009 Jeep Commander 4WD V8-5.7LSECTION Front Fender - Installation
INSTALLATION
1. Position fender (2) on body.
2. Install all screws finger-tight.
3. Align fender with adjacent body panels and reference marks.
4. Tighten all screws to 8.5 Nm (75 in. lbs.).
5. Install rocker panel cover as necessary.
Antenna
If required, install the antenna from the fender.
1. Position the antenna body (3) through the mounting hole in the top of the fender.
2. Install the adapter (4) over the antenna body from the top of the fender.
3. Install and tighten the antenna cap nut (1) using an antenna nut wrench (Special Tool C-4816).
4. Install and tighten the antenna mast (2) onto the antenna body. Ensure that the antenna mast is fully seated on antenna base and that there is no gap between the mast and base.
5. Install front fascia (1) as necessary, Front Bumper Fascia - Installation.
6. Install wheel liner, Splash Shield - Installation
7. Install wheel if removed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.