Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMMANDER 4WD V8-5.7LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTTOWING / TRAILER SYSTEMTRAILER LIGHTING MODULESERVICE AND REPAIRTRAILER TOW MODULE - INSTALLATION
2009 Jeep Commander 4WD V8-5.7L
Trailer Tow Module - Installation
2009 Jeep Commander 4WD V8-5.7LSECTION Trailer Tow Module - Installation
INSTALLATION
1. Position the Trailer Module (TM) (3) over the two studs integral to the mounting plate (5) on the floor of the right cavity of the intermediate step assembly (4).
2. Install and tighten the two nuts (6) that secure the module to the mounting plate studs. Tighten the nuts to 1 Nm (15 in. lbs.).
3. Reconnect the four body wire harness connectors to the module connector receptacles (2).
4. Reinstall the carpeted cover panel over the cavity on the right outboard end of the intermediate step assembly.
5. Restore the right outboard second row seat assembly to its normal seating position.
6. Reconnect the battery negative cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.