Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMMANDER 4WD V8-4.7LREPAIR AND DIAGNOSISBODY AND FRAMEMIRRORSPOWER MIRROR SWITCHTESTING AND INSPECTION
2009 Jeep Commander 4WD V8-4.7L
Power Mirror Switch: Testing and Inspection
2009 Jeep Commander 4WD V8-4.7LSECTION Testing and Inspection
POWER MIRROR SWITCH
1. Disconnect and isolate the battery negative cable. Remove the power mirror switch. Disconnect the wire harness connector from the switch.
2. Test the switch continuity. See the Switch Tests chart to determine if the continuity is correct for the suspect switch in each switch position. If not OK, replace the inoperative switch as required.
POWER MIRROR SWITCH TEST
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.