Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMMANDER 2WD V8-4.7L FLEX FUELREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSKNOCK SENSORSERVICE AND REPAIRKNOCK SENSOR - REMOVAL
2009 Jeep Commander 2WD V8-4.7L Flex Fuel
Knock Sensor - Removal
2009 Jeep Commander 2WD V8-4.7L Flex FuelSECTION Knock Sensor - Removal
4.7L
1. Remove the intake manifold Intake Manifold - Removal
2. Remove the knock sensor bolt.
3. Remove the knock sensor (1).
4. Disconnect the knock sensor wiring harness to the engine harness (1) at the rear of the intake manifold by pressing on lock tab (2).
5. Thoroughly clean the knock sensor mounting hole.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.