Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2009COMMANDER 2WD V8-4.7L FLEX FUELREPAIR AND DIAGNOSISBODY AND FRAMEEXTERIOR MOULDING / TRIMSERVICE AND REPAIRD-PILLAR GRAB HANDLE MOLDING - REMOVAL
2009 Jeep Commander 2WD V8-4.7L Flex Fuel
D-Pillar Grab Handle Molding - Removal
2009 Jeep Commander 2WD V8-4.7L Flex FuelSECTION D-Pillar Grab Handle Molding - Removal
REMOVAL
1. Remove the two push-pin fasteners (2).
For vehicles equipped with applique (4)
1. Using a trim stick C-4755 or equivalent, separate the support clips from the D-pillar and remove.
For vehicles equipped with a grab handle (2)
1. Using a trim stick C-4755 or equivalent, separate the upper (1) and lower (5) covers from the handle.
2. Remove the screws (6) and remove the grab handle (2).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.