Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008PATRIOT LIMITED, FWD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSBODY - INTERIOR & EXTERIORSUNROOFMODULE/FRAME ASSEMBLYREMOVALMODULE/FRAME ASSEMBLY
2008 Jeep Patriot Limited, FWD, Standard
Module/Frame Assembly
2008 Jeep Patriot Limited, FWD, StandardSECTION Module/Frame Assembly
- Move glass panel to fully closed position.
- Disconnect and isolate negative battery cable (4).
- Remove control switch, refer to REMOVAL .
- Remove headliner. See REMOVAL .
- Disconnect the electrical connector.
- Disconnect drain tubes (2) from sunroof housing (1).
- Remove two module side bracket (4) bolts (6) and loosen the six remaining fasteners (3).
- Remove the six (3) fasteners attaching sunroof module assembly (1) to roof panel.
- Remove the glass panel. See REMOVAL .
- Remove the sunshade. See REMOVAL .
- Remove the drive motor. See REMOVAL .
- Remove the wire harness.
- Remove the trough guides. See REMOVAL .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.