Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008PATRIOT LIMITED, FWD, STANDARDLABOR TIMESOTHER VARIANTDRIVELINES AND AXLESDIFFERENTIALS AND DRIVE AXLES - FRONTAXLE SHAFT ASSEMBLYREMOVE & INSTALL OR REMOVE & REPLACE
2008 Jeep Patriot Limited, FWD, Standard
Remove & Install or Remove & Replace
2008 Jeep Patriot Limited, FWD, StandardSECTION Remove & Install or Remove & Replace
WARNING: This page is about the Patriot Sport, 2.0 0, which is a different variant/trim than selected.
TRANSAXLE TYPE
NOTE: For Independent Suspension Type Axles, Axle Shaft Assembly consists of Axle Shaft, Boots and Joints.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Mfr Body CD MK,FWD, Both Sides | DOES NOT include wheel alignment. DOES NOT include drain and refill Transmission Fluid or Fluid Level check. | 1.8 | B | |
| Mfr Body CD MK,FWD, Left | DOES NOT include wheel alignment. DOES NOT include drain and refill Transmission Fluid or Fluid Level check. | 1.0 | B | |
| Mfr Body CD MK,FWD, Right | DOES NOT include wheel alignment. DOES NOT include drain and refill Transmission Fluid or Fluid Level check. | 1.2 | B | |
| Combination Procedure: AXLE SEAL: Remove & Replace: | ||||
| Mfr Body CD MK,FWD, Each | DOES NOT include drain and refill Transmission Fluid or Fluid Level check. | 0.2 | B | |
| Combination Procedure: AXLE SHAFT BOOT KIT: Remove & Replace: | ||||
| Inner &/or Outer,Each Side | 1.0 | B | ||
| Combination Procedure: CONSTANT VELOCITY JOINT: Remove & Replace: | ||||
| Each | 0.5 | B | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.