Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008LIBERTY SPORT, RWD, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMDTCS P2138 TO U110EP2314-IGNITION COIL 5 SECONDARY CIRCUIT- INSUFFICIENT IONIZATIONPOSSIBLE CAUSES
2008 Jeep Liberty Sport, RWD, Automatic
Possible Causes
2008 Jeep Liberty Sport, RWD, AutomaticSECTION Possible Causes
| Possible Causes |
|---|
| (F344) ASD RELAY OUTPUT CIRCUIT |
| (K16) COIL CONTROL 5 CIRCUIT OPEN |
| (K16) COIL CONTROL 5 CIRCUIT SHORTED TO GROUND |
| COIL ON PLUG |
| POWERTRAIN CONTROL MODULE (PCM) |
Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.