Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008GRAND CHEROKEE SRT-8REPAIR AND DIAGNOSISELECTRICALGAUGESOVERHEAD CONSOLE (SERVICE INFORMATION)ELECTRONIC VEHICLE INFORMATION CENTERREMOVAL
2008 Jeep Grand Cherokee SRT-8
Electronic Vehicle Information Center: Removal
2008 Jeep Grand Cherokee SRT-8SECTION Removal
- Disconnect and isolate the battery negative cable.
- Remove the driver airbag, refer to REMOVAL .
- Using a trim stick (special tool # C-4755) or equivalent, gently pry the switch and bezel assembly (3) away from the steering wheel at the inner retaining tab (1) and the outer bezel edge (2).
- With the switch and bezel assembly free from the steering wheel lift the assembly up and disconnect the switch electrical connector.
- Using a trim stick (special tool # C-4755) or equivalent, gently pry the switch bezel retainers (2) away from the switch tabs (1) while applying pressure to the back side of the switch. Remove the switch from the bezel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.