Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008GRAND CHEROKEE SRT-8REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSBODY - INTERIOR & EXTERIORINSTRUMENT PANELASSEMBLY-INSTRUMENT PANELREMOVAL
2008 Jeep Grand Cherokee SRT-8
Assembly-Instrument Panel: Removal
2008 Jeep Grand Cherokee SRT-8SECTION Removal
- Before proceeding with the following repair procedure, review all warnings and cautions. See WARNING .
- Disconnect and isolate battery negative cable.
- Remove the bolts (3) and remove the drivers side hush panel (2).
- Using a trim stick C-4755 or equivalent, separate the upper clips and rotate the cover down and release the lower hinges at the bottom and remove the opening cover.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.