Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSJEEP2008COMPASS LIMITED, FWD, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (POWER TRANSFER UNIT)POWER TRANSFER UNITSTANDARD PROCEDUREPOWER TRANSFER UNIT

2008 Jeep Compass Limited, FWD, Standard

Power Transfer Unit

2008 Jeep Compass Limited, FWD, StandardSECTION Power Transfer Unit

WARNING: This page is about a different variant/trim than selected.

Fig 1: DRAIN AND FILL PLUGS

Courtesy of CHRYSLER LLC

If fluid level is low or fluid change is required fill with MOPAR® MS9020 SAE 80W90 Gear Lube until to bottom of fill plug.
Tighten fill plug (1) to 32 N.m (24 ft. lbs.).
Tighten drain plug (2) to 32 N.m (24 ft. lbs.).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.