Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS LIMITED, FWD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEFUEL DELIVERYFUEL SYSTEMFUEL INJECTION-DIESELSTANDARD PROCEDURESTANDARD PROCEDURE COMMON RAIL DRAINING
2008 Jeep Compass Limited, FWD, Standard
Standard Procedure Common Rail Draining
2008 Jeep Compass Limited, FWD, StandardSECTION Standard Procedure Common Rail Draining
- Remove the vacuum line (1).
- Remove the air cleaner inlet (3).
- Disconnect MAF (3) electrical connector.
- Remove clean air hose (1).
- Remove air cleaner assembly (2).
- Disconnect fuel feed (1) and return lines (2).
- Connect a vacuum pump (2) to the return fuel line (1).
- Operate vacuum pump (2) until no more fuel comes out of the return line (1).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.