Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSJEEP2008COMPASS LIMITED, FWD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICAL2.4L ENGINE (SERVICE INFORMATION)ENGINE BLOCKFRAME-LADDERREMOVALREMOVAL

2008 Jeep Compass Limited, FWD, Standard

Engine Block: Frame-Ladder: Removal: Removal

2008 Jeep Compass Limited, FWD, StandardSECTION Removal

Fig 1: Rear Of Block Ladder Frame Pry Point

Courtesy of CHRYSLER LLC

Remove oil pan. See REMOVAL .
Remove balance shaft assembly. See REMOVAL .
Remove ladder frame retaining bolts.
Remove ladder frame using pry point cast in the rear of the block (1).

Fig 2: Right Side Of Block Ladder Frame Pry Point
Courtesy of CHRYSLER LLC
To assist in removing the ladder frame another (1) pry point cast in the right side of the block.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.