Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS LIMITED, FWD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALCOOLING SYSTEM (MECHANICAL)ENGINE & AUTOMATIC TRANSMISSION COOLING SYSTEMENGINETHERMOSTAT-ENGINE COOLANTINSTALLATIONINSTALLATION-GAS-PRIMARY THERMOSTAT
2008 Jeep Compass Limited, FWD, Standard
Installation-Gas-Primary Thermostat
2008 Jeep Compass Limited, FWD, StandardSECTION Installation-Gas-Primary Thermostat
| 1 - COOLANT HOSE |
| 2 - INLET HOUSING |
| 3 - BOLT |
- Position thermostat into the water plenum, aligning air bleed with the location notch on inlet housing (2).
- Install inlet housing (2) onto coolant adapter. Tighten bolts to 9 N.m (79 in. lbs.).
- Connect coolant hose (1).
- Install air filter housing.
- Fill cooling system. See STANDARD PROCEDURE .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.