Electrical Component Locator: Miscellaneous

2008 Jeep Compass Limited, FWD, StandardSECTION Miscellaneous
MISCELLANEOUS LOCATION

Component Location
A/C Pressure Transducer Top right of radiator. See Figure.
Blower Motor Resistor Lower passenger side instrument panel. See Figure.
Data Link Connector Left side of instrument panel. See Figure.
Driver Airbag Squib 1 Rear of steering wheel pad. See Figure.
Driver Airbag Squib 2 Rear of steering wheel pad. See Figure.
Generator Right front of engine. See Figure.
Ignition Capacitor Left side of engine. See Figure.
Ignition Coil 1 Right top of engine. See Figure.
Ignition Coil 2 Right top of engine. See Figure.
Ignition Coil 3 Left top of engine. See Figure.
Ignition Coil 4 Left top of engine. See Figure.
Passenger Squib Airbag 1 Passenger side of instrument panel. See Figure.
Passenger Squib Airbag 2 Passenger side of instrument panel. See Figure.
Seat Back Heater - Left Left Seat.
Seat Back Heater - Right Right seat.
Seat Belt Tensioner - Driver Driver side "B" pillar. See Figure.
Seat Belt Tensioner - Passenger Passenger side "B" pillar. See Figure.
Seat Cushion Heater - Left Left seat. See Figure.
Seat Cushion Heater - Right Right seat. See Figure.
Starter Left front of engine. See Figure.
Throttle Body Left front of engine. See Figure.
Tire Pressure Transponder - Left Front Rear of left front fender. See Figure.
Tire Pressure Transponder - Left Rear At left rear wheel well. See Figure.
Tire Pressure Transponder - Right Rear At right rear wheel well. See Figure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.