Electrical Component Locator: Connectors

2008 Jeep Compass Limited, FWD, StandardSECTION Connectors
CONNECTORS LOCATION

Component Location
C100 (Black, 8 Pin) Left front engine compartment. See Figure.
C103 (Black, 34 Pin) Left front engine compartment. See Figure.
C104 (Black, 20 Pin) Left front engine compartment. See Figure.
C105 (Dark Gray, 4 Pin) Left front engine compartment. See Figure.
C106 (Black, 6 Pin) Lower front of transmission. See Figure.
C200 (Black, 43 Pin) Left side of instrument panel. See Figure.
C201 (Light Gray, 43 Pin) Left side of instrument panel. See Figure.
C202 (Light Gray, 20 Pin) Base of left "A" pillar. See Figure.
C203 (Light Gray, 12 Pin) Upper right side of instrument panel. See Figure.
C204 (Natural, 10 Pin) Below center console. See Figure.
C300 (Light Gray, 4 Pin) Left side of luggage compartment. See Figure.
C301 (Green, 16 Pin) Left kick panel. See Figure.
C302 (Black, 14 Pin) Left kick panel. See Figure.
C303 (Black, 14 Pin) Below left side of instrument panel. See Figure.
C304 (Light Gray, 14 Pin) Below passenger seat. See Figure.
C305 (Light Gray, 8 Pin) Below driver seat. See Figure.
C306 (Green, 16 Pin) Below left side of instrument panel. See Figure.
C308 (Light Gray, 14 Pin) Left "B" Pillar. See Figure.
C309 (Light Gray, 14 Pin) Right "B" Pillar. See Figure.
C310 (Light Gray, 8 Pin) Body near left top corner of liftgate. See Figure.
C311 (Light Gray, 6 Pin) Body near left top corner of liftgate. See Figure.
C312 (Light Gray, 3 Pin) Left side of instrument panel. See Figure.
C313 (Light Gray, 4 Pin) Left side of luggage compartment. See Figure.
C323 (White, 2 Pin) At left rear body. See Figure.
C325 Left rear of vehicle body. See Figure.
C326 At left rear of vehicle body. See Figure.
C327 At left rear of vehicle body. See Figure.
C328 At right rear of vehicle body. See Figure.
C352 (4 Pin) Under right seat. See Figure.
C353 (4 Pin) Under left seat. See Figure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.