Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS 4WD L4-2.4LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINCONTINUOUSLY VARIABLE TRANSMISSION/TRANSAXLESHIFT INTERLOCKADJUSTMENTS
2008 Jeep Compass 4WD L4-2.4L
Shift Interlock: Adjustments
2008 Jeep Compass 4WD L4-2.4LSECTION Adjustments
ADJUSTMENT
1. Remove shift knob and shift bezel.Console Shifter Bezel - Removal.
2. Remove two screws (1).
3. Pull on side of housing (1) and unsnap housing tabs.
4. Disconnect console housing wire connector (2) and instrument panel connector (3).
5. Remove from vehicle.
6. Adjust interlock cable/system as follows: Pry up on cable adjuster lock to release and allow cable to "self-adjust". Lock cable adjustment by pressing down on the adjuster lock until bottomed at the cable housing.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.