Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS 4WD L4-2.4LREPAIR AND DIAGNOSISSTARTING AND CHARGINGCHARGING SYSTEMALTERNATORSERVICE AND REPAIRGENERATOR - REMOVAL
2008 Jeep Compass 4WD L4-2.4L
Generator - Removal
2008 Jeep Compass 4WD L4-2.4LSECTION Generator - Removal
REMOVAL
1. Disconnect and isolate negative battery cable at battery.
2. Remove the right front wheel.
3. Remove the underbody air dam.
4. Remove the accessory drive splash shield.
5. Remove the accessory drive idler pulley.
6. Loosen the lower mounting bolt.
7. Loosen the A/C compressor and relocate, pull down and to outboard side of vehicle to make room to remove generator.
8. Unplug field circuit from generator.
9. Remove the B+ terminal nut and wire.
10. Remove the upper mounting bolt.
11. Remove the generator lower mounting bolt.
12. Relocate the battery terminal (1) to the other side of the A/C line (2) for removal of the generator.
13. Rotate generator pulley down.
14. Slide generator down and out of vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.