Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS 4WD L4-2.4LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMCAMSHAFT POSITION SENSORLOCATIONSSENSOR-CAMSHAFT 1/2 POSITION
2008 Jeep Compass 4WD L4-2.4L
Sensor-Camshaft 1/2 Position
2008 Jeep Compass 4WD L4-2.4LSECTION Sensor-Camshaft 1/2 Position
Component ID: 132
Component : SENSOR-CAMSHAFT 1/2 POSITION
Connector:
Name : SENSOR-CAMSHAFT 1/2 POSITION
Color : BLACK
# of pins : 3
Qualifier : (GAS)
Pin Circuit Description
1 F855 20PK/YL 5 VOLT SUPPLY
2 K915 20BR/WT SENSOR GROUND
3 K441 20DB/BR CMP 1/2 SIGNAL
Component Location - 16
Component Location - 17
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.