Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS 4WD L4-2.4LREPAIR AND DIAGNOSISDIAGRAMSCONNECTOR VIEWSMANIFOLD PRESSURE/VACUUM SENSOR
2008 Jeep Compass 4WD L4-2.4L
Manifold Pressure/Vacuum Sensor
2008 Jeep Compass 4WD L4-2.4LSECTION Manifold Pressure/Vacuum Sensor
Component ID: 135
Component : SENSOR-MAP
Connector:
Name : SENSOR-MAP
Color : BLACK
# of pins : 3
Qualifier : (GAS)
Pin Circuit Description
1 K1 20VT/LB MAP SIGNAL
2 K900 20DB/DG SENSOR GROUND
3 K857 20BR/LG 5 VOLT SUPPLY
Component Location - 14
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.