Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMPASS 4WD L4-2.4LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTRADIO, STEREO, AND COMPACT DISCRADIO/STEREOSERVICE AND REPAIRREMOVAL AND REPLACEMENTREMOVAL
2008 Jeep Compass 4WD L4-2.4L
Removal
2008 Jeep Compass 4WD L4-2.4LSECTION Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove instrument panel center bezel. Instrument Panel Center Bezel - Removal.
3. Remove mounting fasteners and remove radio from instrument panel.
4. Disconnect wire harness connectors from radio.
CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.
5. Disconnect the antenna cable (3) by pulling the locking antenna connector (2) away from the radio (1).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.