Engine & Automatic Transmission Cooling System: Engine: Pump-Water: Installation: Installation-4.7L

2008 Jeep Commander Overland, RWDSECTION Installation-4.7L
Fig 1: View Of Water Pump & Bolt Tightening Sequence - 3.7L/4.7L - Typical
GC0008365Courtesy of CHRYSLER LLC
1 - WATER PUMP
2 - TIMING CHAIN COVER
  1. Clean gasket mating surfaces.
  2. Using a new gasket, position water pump and install mounting bolts as shown in illustration. For appropriate bolt tightening specification, refer to FASTENER IDENTIFICATION .
  3. Spin water pump to be sure that pump impeller does not rub against timing chain case/cover.
  4. Connect radiator lower hose to water pump.
  5. Install accessory drive belt. See INSTALLATION .
    CAUTION: When installing the serpentine accessory drive belt, belt must be routed correctly. If not, engine may overheat due to water pump rotating in wrong direction.
  6. Refill cooling system. See STANDARD PROCEDURE .
  7. Connect negative battery cable.
  8. Start and warm the engine. Check for leaks.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.