Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMMANDER OVERLAND, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 3 (3.7L ENGINE (SERVICE INFORMATION))ENGINE BLOCKCOVER-STRUCTURALREMOVALSTRUCTURAL COVER
2008 Jeep Commander Overland, RWD
Structural Cover
2008 Jeep Commander Overland, RWDSECTION Structural Cover
WARNING: This page is about a different variant/trim than selected.
- Raise vehicle on hoist.
- Remove the left hand exhaust pipe from exhaust manifold.
- Loosen the right hand exhaust manifold-to-exhaust pipe retaining bolts.
- Remove the eight bolts (1, 2, and 3) retaining structural cover in the sequence shown.
- Pivot the exhaust pipe downward and remove the structural cover.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.