Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSJEEP2008COMMANDER OVERLAND, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (3.7L ENGINE (SERVICE INFORMATION))ENGINE MOUNTINGMOUNT-ENGINE FRONTREMOVALENGINE MOUNT

2008 Jeep Commander Overland, 4WD

Engine Mount

2008 Jeep Commander Overland, 4WDSECTION Engine Mount

WARNING: This page is about a different variant/trim than selected.

Fig 1: Removing/Installing Engine Mount

Courtesy of CHRYSLER LLC

Disconnect negative battery cable.
Raise vehicle.
Remove engine mount through bolts.
Raise engine using suitable jack.
Remove engine mount bolts (2).
Remove mount (1) from engine.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.