Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMMANDER LIMITED, 5.7 2, RWDREPAIR AND DIAGNOSISELECTRICALGAUGESOVERHEAD CONSOLE (SERVICE INFORMATION)OVERHEAD CONSOLE - SERVICE INFORMATIONMODULE-REMOTE COMPASSREMOVAL
2008 Jeep Commander Limited, 5.7 2, RWD
Module-Remote Compass: Removal
2008 Jeep Commander Limited, 5.7 2, RWDSECTION Removal
- Disconnect and isolate the battery negative cable.
- Partially remove the headliner (1) to gain access to the Remote Compass Module (RCM) (2). Refer to REMOVAL for the appropriate procedure.
- Disconnect the RCM electrical connector (3).
- Remove the RCM retaining screws (4).
- Remove the RCM (2) from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.