Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSJEEP2008COMMANDER LIMITED, 4.7 N, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULES (SERVICE INFORMATION)ELECTRONIC CONTROL MODULESMODULE-TRANSMISSION CONTROLREMOVALTRANSMISSION CONTROL MODULE - 3.7L GAS/3.0L DIESEL VEHICLES

2008 Jeep Commander Limited, 4.7 N, RWD

Transmission Control Module - 3.7L Gas/3.0L Diesel Vehicles

2008 Jeep Commander Limited, 4.7 N, RWDSECTION Transmission Control Module - 3.7L Gas/3.0L Diesel Vehicles

Fig 1: Dash Panel Silencer Pad

Courtesy of CHRYSLER LLC

1 - CUT LINES

2 - DASH PANEL SILENCER PAD

3 - STEERING COLUMN LOCATION

Locate the transmission control module on the dash panel, under the dash panel silencer pad (2), just to the right of the steering column. See Fig 1.

Locate the cut lines (1) marked on the silencer pad. Cut the pad along these lines.

Fig 2: Transmission Control Module Location - 3.0L & 3.7L Vehicles

Courtesy of CHRYSLER LLC

1 - TRANSMISSION CONTROL MODULE

2 - DASH PANEL

3 - WIRING CONNECTORS

Remove the transmission control module from the dash panel or bracket.
Disconnect the wiring harness connectors (3) from the module.
Remove the module from the vehicle.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.