Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMMANDER BASE, 4.7 N, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM & WASHER SYSTEM (SERVICE INFORMATION)WIPERS/WASHERSWASHER NOZZLEREMOVALREAR WASHER NOZZLE
2008 Jeep Commander Base, 4.7 N, RWD
Rear Washer Nozzle
2008 Jeep Commander Base, 4.7 N, RWDSECTION Rear Washer Nozzle
- Disconnect and isolate the battery negative cable.
- Remove the Center High-Mounted Stop Lamp (CHMSL) from the liftgate outer panel. Refer to REMOVAL .
- Disconnect the rear washer supply hose from the barbed nipple (4) on the back of the rear washer nozzle.
- From the back of the CHMSL housing, depress the integral latch feature (2) of the nozzle, while pushing downward on the nozzle nipple.
- Disengage the nozzle alignment pins (3) from the receptacle (1) integral to the back of the CHMSL lens and remove the nozzle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.