Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMMANDER 4WD V6-3.7LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMKNOCK SENSORLOCATIONSSENSOR-KNOCK NO. 2
2008 Jeep Commander 4WD V6-3.7L
Sensor-Knock No. 2
2008 Jeep Commander 4WD V6-3.7LSECTION Sensor-Knock No. 2
Component ID: 501
Component : SENSOR-KNOCK NO. 2
Connector:
Name : SENSOR-KNOCK-NO. 2
Color : BLACK
# of pins : 2
Qualifier : (3.7L/5.7L)
Pin Circuit Description
1 K242 20BR/WT KNOCK SENSOR NO. 2 SIGNAL
2 K924 20WT/BR KNOCK SENSOR NO. 2 RETURN
2 K924 20PK/RD KNOCK SENSOR NO. 2 RETURN
Component Location - 19
Component Location - 24
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.