Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMMANDER 2WD V8-5.7LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTANTENNASERVICE AND REPAIRSATELLITE ANTENNAREMOVAL
2008 Jeep Commander 2WD V8-5.7L
Removal
2008 Jeep Commander 2WD V8-5.7LSECTION Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Lower the appropriate portion of the headliner as necessary to access underside of antenna Headliner - Removal.
3. Disconnect the wire harness connectors from the antenna.
4. Remove fastener and retainer.
5. From inside the vehicle, and using a flat bladed tool, depress one of the retaining tabs on the antenna. Push up the one side of the antenna connector through the roof panel. Depress the other side of the connector and remove the antenna.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.