Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMMANDER 2WD V8-4.7LREPAIR AND DIAGNOSISBODY AND FRAMESEATSSERVICE AND REPAIRLUMBAR SUPPORTINSTALLATION
2008 Jeep Commander 2WD V8-4.7L
Installation
2008 Jeep Commander 2WD V8-4.7LSECTION Installation
INSTALLATION
1. Before proceeding with the following repair procedure, review all warnings and cautions. Service Precautions
2. Install the lumbar mechanism (2) and install a new rivet (1).
3. Place lumbar mat onto seat back frame and insert the upper support wires (1) into the frame.
4. Squeeze the lower support wires (1) together and insert into the lower frame.
5. Squeeze the side support wires together and insert them into the sides of the seat back frame.
6. Install the seat back cushion/cover. Seat Back Cushion / Cover - Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.