Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2008COMMANDER 2WD V6-3.7LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLANTILOCK BRAKES / TRACTION CONTROL SYSTEMSELECTRONIC BRAKE CONTROL MODULESERVICE AND REPAIRREMOVAL
2008 Jeep Commander 2WD V6-3.7L
Removal
2008 Jeep Commander 2WD V6-3.7LSECTION Removal
REMOVAL
1. Remove the negative battery cable from the battery.
2. Install a brake pedal prop rod.
3. Siphon the master cylinder.
4. Disconnect the HCU electrical connectors (5).
5. Remove the primary brake line at the master cylinder.
6. Remove the primary brake line from the HCU (4).
7. Remove the secondary brake line at the master cylinder.
8. Remove the secondary brake line at the HCU (4)
9. Remove the 4 chassis lines (3) at the HCU (4).
10. Remove the 1 mounting nut and 1 bolt holding the HCU bracket attachment to the vehicle.
11. Remove the HCU (3) with the bracket (5) from the vehicle.
12. Remove the 3 ABM bolts securing the ABM (1) to the HCU (2).
13. Separate the ABM (1) from the HCU (2).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.