Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2007WRANGLER UNLIMITED SAHARA, RWD, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMDTCS P1607 TO P2138
2007 Jeep Wrangler Unlimited Sahara, RWD, Automatic
DTCS P1607 To P2138
2007 Jeep Wrangler Unlimited Sahara, RWD, AutomaticSECTION DTCS P1607 To P2138
- P1607-Pcm Internal Shutdown Timer Rationality Too Slow
- P1618-Sensor Reference Voltage 1 Circuit Erratic
- P1628-Sensor Reference Voltage 2 Circuit Erratic
- P1696-EEPROM Memory Write Denied/Invalid
- P1697-EMR (Sri) Mileage Not Stored
- P1897-Level 1 Rpm Bus Unlock
- P2072-Electronic Throttle Control System - Ice Blockage
- P2096-Downstream Fuel Trim System 1 Lean
- P2097-Downstream Fuel Trim System 1 Rich
- P2098-Downstream Fuel Trim System 2 Lean
- P2099-Downstream Fuel Trim System 2 Rich
- P2100-Electronic Throttle Control Motor Circuit
- P2101-Electronic Throttle Control Motor Performance
- P2107-Electronic Throttle Control Module Processor
- P2110-Electronic Throttle Control - Forced Limited Rpm
- P2111-Electronic Throttle Control - Unable To Close
- P2112-Electronic Throttle Control - Unable To Open
- P2115-Accelerator Pedal Position Sensor 1 Minimum Stop Performance
- P2116-Accelerator Pedal Position Sensor 2 Minimum Stop Performance
- P2118-Electronic Throttle Control Motor Current Performance
- P2122-Accelerator Pedal Position Sensor 1 Circuit Low
- P2123-Accelerator Pedal Position Sensor 1 Circuit High
- P2127-Accelerator Pedal Position Sensor 2 Circuit Low
- P2128-Accelerator Pedal Position Sensor 2 Circuit High
- P2135-Throttle Position Sensor 1/2 Correlation
- P2138-Accelerator Pedal Position Sensor 1/2 Correlation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.