Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSJEEP2007GRAND CHEROKEE LIMITED, 3.0 M, 4WDREPAIR AND DIAGNOSISBODY & FRAMESEATSBODY - INTERIOR & EXTERIORINTERIORMOLDING-REAR HEADERREMOVAL

2007 Jeep Grand Cherokee Limited, 3.0 M, 4WD

Molding-Rear Header: Removal

2007 Jeep Grand Cherokee Limited, 3.0 M, 4WDSECTION Removal

Fig 1: Removing/Installing Upper Trim Molding

Courtesy of CHRYSLER LLC

Using a trim stick C-4755 or equivalent, disengage the retaining tabs that secure the upper liftgate trim panel to the retaining clips in the liftgate opening and remove the trim panel.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.