Installation

2007 Jeep Grand Cherokee 2WD V8-5.7L VIN 2SECTION Installation





5.7L






CAUTION: Do not use spray (carb) cleaners on any part of the throttle body. Do not apply silicone lubricants to any part of the throttle body.

1. Clean and check condition of throttle body-to-intake manifold O-ring (2).

2. Clean mating surfaces of throttle body and intake manifold.

3. Install throttle body to intake manifold by positioning throttle body to manifold alignment pins.




4. Install 4 mounting bolts (2).

5. Install electrical connector (3).

6. Install air plenum.

7. A Scan Tool may be used to learn electrical parameters. Go to the Miscellaneous menu, and then select ETC Learn.

8. If the previous step is not performed, a Diagnostic Trouble Code (DTC) will be set.

9. If necessary, use a scan tool to erase any Diagnostic Trouble Codes (DTC's) from PCM.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.