Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2007GRAND CHEROKEE 2WD V6-3.0L DSL TURBO VIN MREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONB CODE CHARTSB2205NAVIGATION/TELECOMMUNICATION
2007 Jeep Grand Cherokee 2WD V6-3.0L DSL Turbo VIN M
Navigation/Telecommunication
2007 Jeep Grand Cherokee 2WD V6-3.0L DSL Turbo VIN MSECTION Navigation/Telecommunication
B2205-ORIGINAL VIN MISSING/MISMATCH
For complete wiring diagrams refer to Diagrams/Electrical.
- When Monitored:
With the ignition on.
- Set Condition:
The Hands Free Module will receive and monitor the VIN message from the PCM and record the VIN if different from the last VIN.
Diagnostic Test
1. CHECK FOR ACTIVE DTC
With the scan tool, read the active DTC's.
Cycle the ignition switch from off to on.
With the scan tool, read the active DTC's.
Does the scan tool display this DTC as active?
Yes
- Go To 2
No
- If the DTC is stored, check for an intermittent condition. Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.
2. CHECK VIN IN PCM
With the scan tool compare the VIN that is programmed into the PCM to the VIN on the vehicle.
Does the VIN programmed into the PCM match the vehicles VIN?
Yes
- Inspect the wiring and connectors for damage or shorted circuits. If ok, replace and program the Hands Free Module.
- Perform the BODY VERIFICATION TEST - VER 1. Body Verification Test
No
- Program the correct VIN in the PCM and retest the HFM system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.