Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2006COMMANDER BASE, 3.7 K, AWDREPAIR AND DIAGNOSISBODY & FRAMEFRAMES, SUBFRAMES & CROSSMEMBERSFRAME & BUMPERSCROSSMEMBER-ENGINE CRADLEINSTALLATIONNOTES
2006 Jeep Commander Base, 3.7 K, AWD
CROSSMEMBER-Engine Cradle: Installation: Notes
2006 Jeep Commander Base, 3.7 K, AWDSECTION Notes
- Install the sway bar onto the engine cradle as necessary. (Refer to SUSPENSION/FRONT/STABILIZER BAR - INSTALLATION) .
- Install the lower control arms as necessary. (Refer to SUSPENSION/FRONT/LOWER CONTROL ARM - INSTALLATION) .
- Raise the engine cradle into position guiding the engine mount bolts into the engine cradle slots.
- Install the four engine cradle bolts (1 & 2).
- Align the engine cradle to the marks made during removal and tighten the front bolts (1) to 203 N.m (150 ft. lbs.).
- Tighten the rear bolts (2) to 122 N.m (90 ft. lbs.).
- Install the steering gear as necessary. (Refer to STEERING/GEAR - INSTALLATION) .
- Lower the engine fully onto the engine mounts.
- Tighten the engine mount bolts to 111 N.m (82 ft. lbs.).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.