Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2006COMMANDER BASE, 3.7 K, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESELECTRONIC CONTROL MODULES (SERVICE INFORMATION)MODULE-ENGINE CONTROLINSTALLATION
2006 Jeep Commander Base, 3.7 K, AWD
Module-Engine Control: Installation
2006 Jeep Commander Base, 3.7 K, AWDSECTION Installation
| 1 - ECM ELECTRICAL CONNECTORS |
| 2 - ENGINE CONTROL MODULE (ECM) |
| 3 - ECM MOUNTING BRACKET |
| 4 - ECM MOUNTING BRACKET MOUNTING STUDS |
| 5 - MOUNTING BRACKET RETAINING NUTS |
- Install Engine Control Module (ECM) on bracket (3).
- Position ECM and bracket assembly in vehicle.
- Install ECM bracket to inner fender retaining nuts (5).
- Connect ECM electrical connectors (1).
- Connect negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.