Piston Ring Specifications

2002 Jeep Liberty Limited Edition 2WD V6-3.7L VIN KSECTION Piston Ring Specifications
02' 3.7 v6 SOHC Vin K
Ring Position
NOTE: Piston Rings are installed in the following order: Oil Ring Expander, Upper Oil Ring Side Rail, Lower Oil Ring Side Rail, No.2 Intermediate Piston Ring, No.1 Upper Piston Ring.
Groove Clearance Maximum Clearance
Upper Ring .051-.094mm (0.0020-.0037") 0.11mm (0.004")
Intermediate Ring 0.04-0.08mm (0.0016-.0031") 0.10mm (0.004")
Oil Control Ring (Steel Rail) .019-.229mm (.0007-.0090") .25mm (0.010")
Ring Position Ring Gap Wear Limit
Upper Ring 0.23-0.39mm (0.009-0.015") 0.43mm (0.0017")
Intermediate Ring 0.40-0.66mm (0.015-0.026") 0.74mm (0.0017")
Oil Control Ring (Steel Rail) 0.28-0.79mm (0.011-0.031") 1.55mm (0.061")
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.