Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2002LIBERTY LIMITED EDITION 2WD V6-3.7L VIN KREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - BODY AND FRAMESEAT TEMPERATURE CONTROL MODULESERVICE AND REPAIR
2002 Jeep Liberty Limited Edition 2WD V6-3.7L VIN K
Seat Temperature Control Module: Service and Repair
2002 Jeep Liberty Limited Edition 2WD V6-3.7L VIN KSECTION Service and Repair
Fig.16 Heated Seat Module Location:
REMOVAL
1. Working under the front seat cushion, remove the heated seat module from its mounting bracket by gently prying the module off of the two mounting pushpins.
2. Disconnect the seat wire harness connector from the connector receptacle on the side of the heated seat module.
3. Remove the heated seat module from the vehicle.
INSTALLATION
1. Connect the seat wire harness connector to the connector receptacle on the side of the heated seat module.
2. Install the heated seat module on its mounting bracket under the front seat.
3. Verify heated seat system operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.