Trailer Hitch: Service and Repair

2002 Jeep Liberty Limited Edition 2WD V6-3.7L VIN KSECTION Service and Repair
TRAILER HITCH

REMOVAL




1. Remove the tow hooks, if equipped.
2. Disconnect trailer electrical connector.
3. Support the hitch with a suitable lifting device.




4. Remove the bolts and remove the trailer hitch.

INSTALLATION

1. Support the hitch with a suitable lifting device and install the hitch.




2. Install the bolts (1) and tighten to 88 N.m (65 ft.lbs.)
3. Connect the electrical connector.




4. Install the tow hooks, if required.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.