Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2002LIBERTY LIMITED EDITION 2WD V6-3.7L VIN KREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTTRIP COMPUTERSERVICE AND REPAIRCOMPASS/MINI-TRIP COMPUTER REPLACEMENT
2002 Jeep Liberty Limited Edition 2WD V6-3.7L VIN K
Compass/Mini-Trip Computer Replacement
2002 Jeep Liberty Limited Edition 2WD V6-3.7L VIN KSECTION Compass/Mini-Trip Computer Replacement
REMOVAL
1. Remove overhead console, refer to Console Removal and Installation in this section.
2. Remove mounting screws and release the map lamp wire connector from the compass mini-trip computer..
3. Remove the compass mini-trip computer from the overhead console.
INSTALLATION
1. Install the compass mini-trip computer in the overhead console. Align the compass mini-trip computer guides on the housing with the grooves of the console.
2. Install the mounting screws and install the map lamp wire connector on the compass mini-trip computer. Make sure the LOOP of wire that was clipped into the compass mini-trip computer module housing is properly clipped into the new module before the console is placed back into the headliner.
3. Install the overhead console, refer to Console Installation in this section.
1. Remove overhead console, refer to Console Removal and Installation in this section.
OTIS Removal:
2. Remove mounting screws and release the map lamp wire connector from the compass mini-trip computer..
3. Remove the compass mini-trip computer from the overhead console.
INSTALLATION
1. Install the compass mini-trip computer in the overhead console. Align the compass mini-trip computer guides on the housing with the grooves of the console.
2. Install the mounting screws and install the map lamp wire connector on the compass mini-trip computer. Make sure the LOOP of wire that was clipped into the compass mini-trip computer module housing is properly clipped into the new module before the console is placed back into the headliner.
3. Install the overhead console, refer to Console Installation in this section.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.