Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2002LIBERTY LIMITED EDITION 2WD V6-3.7L VIN KREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTANTITHEFT AND ALARM SYSTEMSKEYLESS ENTRYKEYLESS ENTRY TRANSMITTERTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGTRANSMITTER PROGRAMMING
2002 Jeep Liberty Limited Edition 2WD V6-3.7L VIN K
Transmitter Programming
2002 Jeep Liberty Limited Edition 2WD V6-3.7L VIN KSECTION Transmitter Programming
STANDARD PROCEDURE - RKE TRANSMITTER PROGRAMING
New Remote Keyless Entry (RKE) transmitters can be programed using the DRBIII scan tool and the proper Diagnostic Procedures manual. The DRBIII scan tool can provide confirmation that the PCI data bus is functional, and that all of the electronic modules are sending and receiving the proper messages on the PCI data bus.
The following procedure can be used as long as one functioning transmitter is available:
1. Using the original transmitter, press the UNLOCK button for 4 to 10 seconds.
2. Without releasing the UNLOCK button, press the PANIC button (within the 4 to 10 second interval).
3. Release both buttons.
4. Press LOCK and UNLOCK simultaneously on the original transmitter.
5. Release both buttons.
6. Press any button on the ORIGINAL transmitter. A chime tone from the instrument cluster will confirm the programming of the ORIGINAL transmitter.
7. On NEW transmitter, press LOCK and UNLOCK simultaneously.
8. Release both buttons.
9. Press any button on the NEW transmitter. A chime tone from the instrument cluster will confirm the programming of the NEW transmitter.
10. Up to four transmitters can be programed for one vehicle.
New Remote Keyless Entry (RKE) transmitters can be programed using the DRBIII scan tool and the proper Diagnostic Procedures manual. The DRBIII scan tool can provide confirmation that the PCI data bus is functional, and that all of the electronic modules are sending and receiving the proper messages on the PCI data bus.
The following procedure can be used as long as one functioning transmitter is available:
1. Using the original transmitter, press the UNLOCK button for 4 to 10 seconds.
2. Without releasing the UNLOCK button, press the PANIC button (within the 4 to 10 second interval).
3. Release both buttons.
4. Press LOCK and UNLOCK simultaneously on the original transmitter.
5. Release both buttons.
6. Press any button on the ORIGINAL transmitter. A chime tone from the instrument cluster will confirm the programming of the ORIGINAL transmitter.
7. On NEW transmitter, press LOCK and UNLOCK simultaneously.
8. Release both buttons.
9. Press any button on the NEW transmitter. A chime tone from the instrument cluster will confirm the programming of the NEW transmitter.
10. Up to four transmitters can be programed for one vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.