Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2002LIBERTY LIMITED EDITION 2WD V6-3.7L VIN KREPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONMANUFACTURER CODE CHARTSINTERIOR LIGHTINGDIMMING LEVEL SWITCH INPUT CIRCUIT LOW
2002 Jeep Liberty Limited Edition 2WD V6-3.7L VIN K
Dimming Level Switch Input Circuit Low
2002 Jeep Liberty Limited Edition 2WD V6-3.7L VIN KSECTION Dimming Level Switch Input Circuit Low
Tests 1 - 2:
Tests 3 - 4:
SYMPTOM
DIMMING LEVEL SWITCH INPUT CIRCUIT LOW
WHEN MONITORED
ignition ON.
SET CONDITION
BCM detects a voltage less than 0.25 volts on the dimming level switch input for more than 5 seconds.
POSSIBLE CAUSES
- Intermittent condition
- Panel lamps dimmer switch MUX open
- Panel lamps dimmer switch MUX circuit shorted to ground
- Multifunction switch
- Body control module
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.