Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Jeep Grand Cherokee OverlandFACTORY OEM SERVICE PROCEDURE
Demagnetize Compass
Possible Causes are:
- DEMAGNETIZE COMPASS
- A blank compass display indicates that vehicle demagnetizing is required. After demagnetizing, the vehicle will enter Auto Fast-Cal when the ignition is turned on. Ensure that the correct compass variance is stored in the compass memory. See SETTING MAGNETIC ZONE VARIANCEΒ under COMPASS in PROGRAMMING.
- Perform Demagnetizing Procedure. See COMPASS DEMAGNITIZINGΒ under SERVICING. When demagnetizing procedure is complete, perform the Verification Test. See BODY VERIFICATION TEST VER 1Β under VERIFICATION TESTS.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
