Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1999WRANGLER L4-2.5L VIN PREPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSUSPENSIONSTABILIZER BARSERVICE AND REPAIRREAR
1999 Jeep Wrangler L4-2.5L VIN P
Rear
1999 Jeep Wrangler L4-2.5L VIN PSECTION Rear
REMOVAL
1. Raise and support the vehicle.
2. Remove the stabilizer bar link bolts from the frame mounts.
3. Remove the link bolts from the stabilizer bar.
4. Remove the stabilizer bar retainer bolts and retainers from the axle mounts and remove the bar.
INSTALLATION
1. Install the stabilizer bar on the axle mounts and install the retainers and bolts.
NOTE: Ensure the bar is centered with equal spacing on both sides and is positioned above the differential housing.
2. Tighten the retainer bolts to 54 Nm (40 ft. lbs.).
3. Install the links onto the stabilizer bar and frame mounts. Install the bolts and nuts finger tight.
4. Remove support and lower vehicle.
5. Tighten the link nuts/bolts to 54 Nm (40 ft. lbs.).
1. Raise and support the vehicle.
2. Remove the stabilizer bar link bolts from the frame mounts.
3. Remove the link bolts from the stabilizer bar.
Stabilizer Bar:
4. Remove the stabilizer bar retainer bolts and retainers from the axle mounts and remove the bar.
INSTALLATION
1. Install the stabilizer bar on the axle mounts and install the retainers and bolts.
NOTE: Ensure the bar is centered with equal spacing on both sides and is positioned above the differential housing.
2. Tighten the retainer bolts to 54 Nm (40 ft. lbs.).
3. Install the links onto the stabilizer bar and frame mounts. Install the bolts and nuts finger tight.
4. Remove support and lower vehicle.
5. Tighten the link nuts/bolts to 54 Nm (40 ft. lbs.).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.