Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1997GRAND CHEROKEE TSI, 5.2 Y, AWDREPAIR AND DIAGNOSISBODY & FRAMEBODY, CAB CONTROL SYSTEMSBODY CONTROL COMPUTERTESTINGVEHICLE COMMUNICATIONSTEST 18A - BUS OPEN
1997 Jeep Grand Cherokee TSi, 5.2 Y, AWD
Test 18A - Bus Open
1997 Jeep Grand Cherokee TSi, 5.2 Y, AWDSECTION Test 18A - Bus Open
- Disconnect Body Control Computer (BCM) connectors. BCM is located under left side of instrument panel. Connect jumper wire between ground and terminal No. 19 (Violet/Brown wire) on BCM Black connector. Using scan tool, select SYSTEM MONITOR. Perform CCD BUS test. If scan tool does not display BUS SHORT TO GROUND, repair open Violet/Brown wire. If scan tool displays BUS SHORT TO GROUND, go to next step.
- Move jumper wire to terminal No. 20 (White/Black wire) on BCM Black connector. Perform CCD BUS test. If scan tool does not display BUS SHORT TO GROUND, repair open White/Black wire. If scan tool displays BUS SHORT TO GROUND, replace scan tool cable or scan tool.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.