Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1997CHEROKEE SE, 4D UTILITY, 4.0 S, 4WD, STANDARDLABOR TIMESOTHER VARIANTTRANSMISSIONAUTOMATIC TRANSTRANSMISSION OIL PAN &/OR GASKETREMOVE & REPLACE
1997 Jeep Cherokee SE, 4D Utility, 4.0 S, 4WD, Standard
Transmission Oil Pan &/Or Gasket: Remove & Replace
1997 Jeep Cherokee SE, 4D Utility, 4.0 S, 4WD, StandardSECTION Remove & Replace
WARNING: This page is about the Cherokee SE, 2D Utility, 2.5 P, 4WD, Automatic, which is a different variant/trim than selected.
3 SPEED TRANS, TRANS ID - A727, A904, A999, 30RH, 31RH, 32RH, 36RH
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Trans Mfr CD 30RH | 0.8 | 0.6 | C | |
| Combination Procedure: KICKDOWN BAND: Adjustment: | ||||
| Trans Mfr CD 30RH | 0.1 | B | ||
| Combination Procedure: LOW & REVERSE SERVO BAND: Adjustment: | ||||
| Trans Mfr CD 30RH | 0.1 | B | ||
| Combination Procedure: THROTTLE LINKAGE: Adjustment: | ||||
| Trans Mfr CD 30RH, Clutches & Bands | 0.1 | C | ||
| Trans Mfr CD 30RH, Throttle & Regulator Valve | 0.1 | C | ||
| Trans Mfr CD 30RH, Throttle Valve Linkage | 0.1 | C | ||
4 AND 5 SPEED TRANS, TRANS ID - AW4, 30-40 LE, 42RE,42RLE,42RH, 44RE, 45RFE, 46RH, 46RE, 545RFE, NAG1,W5A580
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| 0.8 | 0.6 | C |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.