Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1994WRANGLER SAHARA, AUTOMATIC, 32RHREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEREMOVE, OVERHAUL & INSTALLENGINE CONTROLS - REMOVE/INSTALL/OVERHAULIGNITION SYSTEMDISTRIBUTORREMOVAL
1994 Jeep Wrangler Sahara, Automatic, 32RH
Ignition System: Distributor: Removal
1994 Jeep Wrangler Sahara, Automatic, 32RHSECTION Removal
- Disconnect negative battery cable. Remove distributor cap. Rotate engine crankshaft until distributor rotor is pointing toward cylinder No. 1 of distributor cap and engine is at TDC.
- Scribe mark on distributor and adjacent component as reference to indicate rotor and distributor housing position when reinstalling distributor. Disconnect camshaft position sensor harness connector. Remove distributor hold-down nut. Lift distributor from engine.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.