Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP1994CHEROKEE SPORT, 2D UTILITY, 4WD, AUTOMATICREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEMPROGRAMMINGTRANSMITTER
1994 Jeep Cherokee Sport, 2D Utility, 4WD, Automatic
Keyless Entry System: Programming: Transmitter
1994 Jeep Cherokee Sport, 2D Utility, 4WD, AutomaticSECTION Transmitter
Up to 4 Transmitter Identification Codes (TICs) can be programmed into receiver at any given time.
- Open driver's door of vehicle. Leave it open through the programming procedure.
- Move mechanical door lock lever to the LOCK position.
- Insert ignition key and turn it to ON position.
- Within 20 seconds, aim a transmitter at receiver dome and press lock button, for at least 5 seconds. Once receiver accepts programming code the driver's door will unlock.
- Once first transmitter has been programmed, additional transmitters (up to 4) may be programmed into receiver. Within 20 seconds of the previous transmitter programming, move the mechanical door lock lever to LOCK position. Aim another transmitter at receiver dome and press LOCK button for at least 5 seconds. The door lock will cycle again.
- To lock the programmed codes into the receiver, the ignition must be turned off and back on within 20 seconds after programming the last transmitter's code. At that time, all previous codes are erased from the module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.