Test VER-1 - Verification Procedure

1994 Jeep Cherokee Country, 4D Utility, RWDSECTION Test VER-1 - Verification Procedure
  1. Ensure ignition is off and DRB is connected. Reconnect all previously disconnected components and connectors. Turn ignition on. If DRB screen is blank, go to TEST 2A - BLANK DRB MESSAGE SCREEN  . If DRB screen is not blank, go to next step.
  2. If there is a BUS failure message on DRB, go back to TEST 1A - TROUBLE CODES  . If there is no BUS failure message on DRB, select module in question. If DRB shows NO RESPONSE, go back to TEST 1A - TROUBLE CODES  .
  3. If DRB does not show NO RESPONSE, inspect vehicle for original complaint. If original complaint is present, go to TEST 1A - TROUBLE CODES  . If original complaint is not present, repair is complete.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.